TBS Source ONE Frame extension for DJI FPV system
Description
The DJI FPV is awesome, but doesn't fit well in the TBS SourceOne frame (it's slightly too long). This extends the rear of the SourceOne frame just enough to fit the DJI system inside. Best designed to use with https://www.thingiverse.com/thing:4208083 or https://www.thingiverse.com/thing:3781093 Parts needed: 4x - M3 10mm (or possible 8mm in a pinch) 4x - Nuts 2x - Factory standoffs 4x - Factory standoff bolts Notes: Press the factory standoffs into the optional GPS Mount for maximum strength. Use zipties or doubled sided tape to secure the DJI receiver. Also use zipties to secure both the DJI and receiver antennas. Infill 100% (probably not needed but helpful since the part is so small. Side Note: I did use an extra optional M3 bolt and nut to "level" the dji receiver so it looks level in the frame. Peace!
Statistics
Likes
2
Downloads
0