Revolver (Single Action, Gas Seal)
Description
This is a revolver, made for my own 8mm airsoft cartridges as seen on YouTube. It is inspired by the "Single Action Army" revolver. It has a gas seal mechanism similar to the Nagant revolver, which is neccessary due to the small amount of air in the cartridges. Print settings are below. Support is not needed, except on the trigger guard of the main-frame (you'll see). Cylinder and especially cylinder shaft should be printed with random layer starting points, to avoid a seam. If you have any questions, comment on any video of DerKrawallkeks on YouTube.
Statistics
Likes
27
Downloads
0