Honda Pilot Cup Holder Improved
Description
I remixed the cup holder foam so that I could print it in TPU. I had to scale it down about 2% to make it line up with the mounting pegs and add some additional holes because at this thickness the TPU was too strong for a normal fast food cup. These have been installed in my Pilot for about two months without any issues. We daily use a 30 oz Yeti mug in the driver side with no noticeable defects. We have not been through a hot summer yet so, I'm not sure if we will have sagging from the heat but, it's better than a torn foam rubber piece.
Statistics
Likes
10
Downloads
0