Redesigened Prusa Face Shield for very efficient printing
Description
Many maker hubs are currently pinting the Prusa face shields. But even the latest versions take a long time to print. I decided to design a pin compatible face shield which is printable in spiralized vase mode. With a Tronxy X5S I achieved a print time of 35 minutes at 100mm/s print speed. Edit 04/13/2020 added a STL file with 3 Pins used by US letter 3 hole punches. Pros: minimized filament use of about 16g more flexible than the original to fit to the face better. allmost constant and linear print speed gives good print results and good bed adhesion no travels no retractions required no stringing for PET-G filament Cons: optimized for 0.4mm nozzles no stackable design rubber mounts are diffetent from Prusa design Please note: This is no medical approved thing, use at your own risk.
Statistics
Likes
15
Downloads
0