Uncle Bens Ender 3 & Ender 3 Pro Fang for 40mm Fans with BLTouch and Neopixel support
Description
<b>Introduction:</b> Remix of jckz82's fang and StevenMLawson's BLTouch mount plus an optional LED strip mount. The fang is kept in place by the two screws which go through the hotend. The pictures show the orientation to print in. <b>Mounting requires:</b> - 2x M3x20 for the hotend (M3x18 will also work) - 8x M3x20 for the fans (20 is an example for 10mm thick fans. The actual length depends on your fans - super/hot glue will also work) - optional: 10mm wide and max. 100mm long LED strip <b>Instructions:<b> - Print with 0.2 resolution - Print with supports "touching build plate" (both the fanduct and the led mount) - See screenshot for printing orientation - Be sure to mount the hotend fan like this: The screw goes through the LED mount, then through the fan, then inside the fanduct - BLTouch offsets in mm: X -48.0, Y -28.0, Z -1.15
Statistics
Likes
143
Downloads
0