USB Holder (2 x 2) Minimal Design
Description
Similar to my 3 x 3 Design, but now smaller 2 x 2 - Minimize print time (Estimated 56 minutes) and filament - Minimize desk space ( 45 mm x 37.3 mm ) - USB Slot is through-hole to prevent dust collection, therefore easy to clean - Slots are spaced to accommodate various USB sizes, and enough room for you finger to grab when its filled with USB's - Same spacing as the 3 x 3 design - Has 0.10mm width/length tolerance for male USB Type A plug - Every edge is filleted (rounded) to prevent cuts - Chamfered at the base for strength - 3 mm thick base, 2 mm wall thickness (won't bend or break) - Can be used upside down if preferred
Statistics
Likes
0
Downloads
0