Economic PSU support for Ender 3 and Ender 3 Pro
Description
Economic low profile support that couples under the power supply unit of Ender 3 and Ender 3 Pro standard versions. It clips on the lower rail and holds the PSU at the base in order to reduce stress by overhanging weight in Z axis. Installing instructions: Just insert in rail and push the support against PSU base. Pull PSU base upwards a little while pushing the piece until it fully slides and locks in place. Troubleshooting: If piece is loose either increase horizontal expansion or overall size by a small increment. Piece is supposed to fit tight in place while not pushing the PSU upwards too hard.
Statistics
Likes
9
Downloads
0