ATH-M50X Hinge fix (pure PLA, no tools required)
Description
This is a replacement part for the little nub thing on the ATH M50X that keeps each hinge from hyper-extending. This build requires NO SCREWS, NO GLUE, NO TOOLS, just regular PLA. I've done some varies designs to increase strength of the pieces. Should be printed in the orientation of the STL file. Part 1 is printed flat Part 2 is printed at a 45 degree The two piece is a tight fit, there is designed no clearance between the parts, so the slight flex in PLA is needed to allow the pieces to fit. Updated V2: Rotated piece part 2 so the lock piece slides in from the top. Slightly harder to put together, but now the lock piece doesn't slowly fall out. I've found that this solution last a couple of month with low-medium use. When it breaks, just print another one. I might make a smaller version with standard size screws in the future if there is demand for it. Original design found here: https://www.tinkercad.com/things/iLHbotOYmf8
Statistics
Likes
3
Downloads
0