Raspberry Pi case with Pi Camera for Prusa MK3
Description
The [CR-10 case by ksamuelsen][1] modified to attach to a Prusa MK3S. This case has an adjustable arm for the camera, attaches nicely to the side of a Prusa MK3S, and doesn't require any disassembly of your printer (unlike a lot of the Pi cases that house it in with the Einsy board). ksamuelsen's designe was for the CR-10, which evidently has different rails from the MK3S, so I snagged a different style of attachment clips from these [sideboxes][2] by KalleKnall and jammed them on there instead of the originals. Only the bottom piece has been changed from ksamuelsen's original files. Use their assembly instructions. ### Notes * Do not try to put M3 screws through the holes in the Raspberry Pi!! Those are M2.5 holes. If you don't have M2.5 screws, just leave it loose in there. It wiggles a bit but it's fine. * The camera case is supposed to be press-fit. When I printed it, it was very loose. I hold it closed with a binder clip for now. [1]: https://www.thingiverse.com/thing:3079477 [2]: https://www.prusaprinters.org/prints/974
Statistics
Likes
1
Downloads
0