Flexible Bike Smartphone Mount
Description
**20-04-23 Update:** Added a printable thumbscrew bit for use on a M5 hex head bolt. Alternatively you can use a M5 coutersunk head bolt without the thumbscrew A flexible smartphone holder to go on a (motor-)bike handlebar. It is designed to hold the phone tight, but also dampen shocks so it can be used on MTB-Trails. (My old commercial holder broke) So far, it works very well. **Additional required items:** 1x M5x25 bolt countersunk head OR hex head if you want to use the thumbscrew 1x M5 nut 2x M4x10 bolt (countersunk head) 2x M4 nut 1x piece of old bike tube to go between the clamp and the bar **Includes the following sizes:** bar clamps for 32, 26 and 22mm bar diameter Flexible bits for 6", 5" and 4" phones Fusion 360 source included, as always. Post your makes ;) ### DON'T SKIP THE PRINT INSTRUCTIONS: - **THE GREEN BIT MUST BE PRINTED OF FLEXIBLE TPU** - **THE ORANGE CLAMP MUST BE PRINTED OF PETG** - PLA is too brittle and would just snap - The clamp must be printed in horizontal orientation, as shown on the slicer picture. Otherwise it will snap - print the thumbscrew very slowly to make the layer bonding strong
Statistics
Likes
121
Downloads
0