Small box for small PCB, a switch, a potentiometer, and two cables
Description
This is a box for a custom dimmer board I made, but it can be used for anything as long as it fits. Cutout sizes: Round hole: 10.5mm (for a standard potentiometer) Rectangular hole: 12.7 x 20.6mm (for a standard AC switch) Box internal sizes: 45 x 45 x 26 mm There are two V shaped slots in the rear that can be used to catch onto cables and hold them in place. I used speaker wire and it holds on to it quite well. Be sure to calibrate your flow as the tolerances are tight, the two halves should snap into each other quite nicely.
Statistics
Likes
6
Downloads
0