Camera Sun Hood DJI Mavic Air Drone
Description
When you print one of these please post a picture of let me know what you think of it. This is a clamp on sun shade for the dji mavix air drone. When clammed on the view angle of the camera is smaller than the cap so it will not be seen in the shot. Sometimes when the sun is a bit lower in the sky it can happen that the sun rays will shine directly onto the lens eventhough the sun is not to be seen at that moment in the shot. The direct rays will reflect inside the camera housing causing a bad recording. This easy to add sun shade can help with that. It is supposed to be printed in a flex material. A bolt hole was not modelled and needs to be made after printing by using a redhot needle. I used a m2 bolt but even smaller would be better. Do not overclamp it. It needs nothing more than a little clamping force to keep it on. When you switch the drone on it will allways move the camera up and down to check or adjust some settings. Just lift the drone during this startup and do not land it with the cam looking down unless you use leg extensions on the drone. I do not think it will give any problems while flying. (My camera does not go more up (by setting) than level. I have not experienced any problems with the forward obstacle sensors and also think that there is no problem from the propwash hitting the hood. The props are almost flat at the tip so I guess the will be hardly any propwash going down at this location.
Statistics
Likes
1
Downloads
0