Montana Mask seal mold
Description
This is a mold to use in addition to montana mask design. I am using 00-30 two part silicone for this, but any flexible silicone or rubber should work with this mold. Using the 00-30 silicone found here : https://www.amazon.com/gp/product/B00CA5VY3U/ 1. mix 2. pour 3. let cure for 4 hours glue to mask with sil-poxy or another good rtv glue This will scale to different sizes, just print in whatever scale the mask was printed in L - 100% (most male faces) M - 95% (most female faces)
Statistics
Likes
24
Downloads
0