Makita Drill BDF343 Wall Mount with orig. Belt Clip
Description
I remixed it because if have the original Beltclip mounted on the drill (visible on the Fotos) So i had to make it a little bit higher to be able to use this. I also increased the cutout on the front so save some filament and printtime. I also removed the hole in the middle. Only small supports at the overhang, where the wireless drill is sliding in, is needed. I followed the instructions of GunSmoker with 5 top layers 4 wall and 4 bottom layers. It works fine and is very stable!
Statistics
Likes
14
Downloads
0