Hamama Quilt Lifter 20mm
Description
A very simple design, this is for raising up Hamama microgreen quilts so that the top of the quilt fabric is basically aligned with the edge of the tray. The roots happily go down into the water, and the coconut coir can sit in the water, leaving the fabric/seeds on top not sitting in water. I shoot a lot of time lapse videos of my Hamama microgreens. It's fun, and people seem to enjoy them. The problem is, it's hard to shoot from the side, because the quilt sits down in the tray, so the tray is in the way. With this, I can start a photoshoot from the side, focusing just on the seeds in the lower part of the frame, and after 3 or 4 days, watch them grow straight up. Not something you can do from the angles required without these risers. You can, of course, use this for anything you'd like! If you need something like this in any other reasonable dimension, just let me know. I need to know the length, width and height. For the purposes of this discussion, "width" is the length of the slats, "length" is the other direction, and "height" is how tall you want it. In mm. I don't do inches. These fit the standard black Hamama tray to within 1mm all around. Not tight, but not much movement. Print this with PLA if you want it to be semi-food-safe. Who knows what nastiness the ABS would leech into the roots and your sprouts! In order for these to work properly, you have to put the riser slats perpendicular to the tray's slats. If you put them parallel, I will laugh at you, until I realized you basically invented a slightly shorter riser. So who's laughing now?
Statistics
Likes
9
Downloads
0