Bear extruder filament sensor lever fix 0.7.0-beta MK2.5S MK3S
Description
UPDATE: If u are here, maybe your problem is not, that u need my design, maybe you just need to turn off the "thin wall detection in your slicer" if that dosnt work, you´re welcome to try my design. i just made the little nose that goes intro the sensor a little bit thicker. My slicer just wont slice the last little edge, cause it was to thin. So i fixed this. (thin wall detection was on in my slicer) U can see the different on second picture, the right one is the fixed one.
Statistics
Likes
0
Downloads
0