iris rev4 middle layer led backlight cutouts with 15deg tent legs
Description
Made these two designs for the iris rev4 because I was unable to see the backlighting on the board with a solid middle layer. One has the full middle layer frame and one is just the cutouts of the legs. The holes accommodate the M2 12mm standoffs. I only uploaded the left hand side but to get the right hand side just mirror it in your slicer. This is an edit of this model https://www.thingiverse.com/thing:4000735 Credit for that model goes to Joe Scotto his page can be found here https://www.thingiverse.com/joe_scotto/about
Statistics
Likes
3
Downloads
0