Ugly Tyro69 TPU
Description
This is for TPU only. I was sick of how the uneven spacers that were included looked. 3mm spacer goes between the frame and the ESC. 4mm spacer goes between the ESC and the Flight Controller. 5mm spacer goes between the Flight controller and the canopy. for best results I printed one spacer at a time. When putting the canopy on. have the vtx/camera and rx hanging off the back. Put the VTX antenna through the loop. Then the camera. I have my RX shrink wrapped on top of the VTX. I use electric tape to hold it in place. You could use double sided tape to hold the VTX in and the RX on top of that. Feed the RX wires through the holes and then shrink wrap. Camera is at a 30 degree angle.
Statistics
Likes
3
Downloads
0