Z-Tops (no Bear Firmware needed) Bear Extruder and X axis 0.7.0-beta MK2.5S MK3S
Description
I modified the Z-Tops for the Prusa i3 mk3s Full Bear. So that u will don´t need the Bear firmware, and can run the (xy) Z Calibration with original Prusa Firmware. The thing is testet only by me, curently. I will be thankfull, if u tell me in comments if its work for u too. If u have trouble, maybe try to lower ur PINDA, mine is atm at 0,9 -1mm from printbed while nozzle is touching it. And make shure ur ZipTies dont touching the frame, there is not much space (see pic). For Printing, i think u need more infill than normaly, because i made the Z-Tops thiner than usualy. I printed with 50-60% infill, and 0.15 layerhight 3 primeters. 2mm Layerhight should also work fine. Just try and have fun.
Statistics
Likes
7
Downloads
0