Adjustable Can Handle (0.33 and 0.5)
Description
The purpose of this remix is so it fits both 0.5 and 0.33 beer cans. I've done some things to the design. I have first of all shortened it so it can fit a 0.33 beercan I also added bottom support for the design, so it doesn't tilt by accident while in use. I have lengthened the sliding area for the M3 nut. When i shortened the design of the handle, the original knob wouldn't fit and was tricky to use, so I redesigned the adjustment knob for easier usage. Hardware: 3x M3 nut 1x M3x19mm screw. (i assembled it with 2x nuts inside the knob. Without the second one the m3 screw would stick too far out and puncturing the can) You can print all at once, but the part require some different settings. I printed it in 0.15 scale with 4 walls The bottom part: 25% Infill (i use qubic infill) No support (Print Standing) The Handle: 20% Infill (i use qubic infill) with support (touching buildplate) Adjustment knob: 60% Infill no support (I actually printed the knob in 100% infill :P)
Statistics
Likes
5
Downloads
0