Ender 3 Zed Sleeve Filament Protector
Description
NO TOOLS NEEDED This is quite possibly the simplest filament protector you will find. The large end is sized to "press fit" over the ZED screw bushing allowing it to stay in place without any screws. The inside diameter is stepped from 13mm to 9mm allowing it to fit the bushing and let the 8mm ZED screw twist freely inside of it. I'd recommend rotating the part so the larger end is facing UP during printing for a better print. I printed this on the lowest resolution possible and it fits just fine. I may try a version 2.0 that allows the smaller portion to spin freely reducing wear. However over the course of time while printing if you do notice it starting to wear all you will need to do is turn it slightly to a fresh spot. :) ENJOY
Statistics
Likes
2
Downloads
0