Arrma Infraction Side Skirts V2 (with rock deflector)
Description
I went ahead an updated the Arrma Infraction side skirts to add a rock deflector. This should prevent some rocks from getting kicked up into the body. You also need a large sized bed. I was able to print this on my CR10 laid out diagonally. fwiw, I printed without supports except at the bottom edge of the deflector. Since pics taken.. changes made below. I removed the old model and not going to bother reprinting them but the changes are listed below. If someone posts a make.. I'll use their pic. NOTE: 1. thickened deck to 2.5mm 2. added ribs to strengthen layers 3. notched out corner of deflector to avoid inner body fender flares 4. removed one brace to clear out room for body when installed. 5. thickened existing braces by .5mm 6. adjusted screw holes a bit.. was off by .25mm on a couple of them. Made lining up the guides difficult. 7. added logo less version. I also can do custom models w/ your RC club name or whatever is doable on the top of the skirts for a tip. msg if interested
Statistics
Likes
30
Downloads
0