M42 Camera Body Cap (FUJICA)
Description
M42 threaded, so should fit any camera body that uses the M42 Mount. Although the label says Fujica. Printing directions to ensure a good fit: 1. Turn off support structures 2. 0mm-5mm print at whatever layer height you like 3. 5mm+ print at 0.05mm layer height (for the thread) 4. Print from inside out (if possible) to minimize bubbles appearing on the outside of the thread. Doge donations: D5cqNG1nHCRWeyFHv5LaJNrMP54MVyM2Az Much appreciated!
Statistics
Likes
1
Downloads
0