Raspberry Pi 3 Case Deep (Remix)
Description
This is a remix of http://www.thingiverse.com/thing:2205034 http://www.thingiverse.com/thing:1043432 This case is for a Raspberry Pi3, after printing the original and fitting a 40x40x10 fan i found clearance issues with the poe pins and the ribbon for the pi camera. I redesigned in TinkerCad to make the top of the case deeper to provide clearance, i also added a slot above the ethernet port to feed the ribbon cable out of for the camera. You will need 3x M4 nuts and bolts for the case 4x M3 nuts and bolts for the fan 4x M2 nuts and bolts for the pi I filed out the pi mount holes on the case a little and used 4x Pi Mounting Pins http://www.thingiverse.com/thing:2572048 The nuts can be heated up on the tip of a soldering iron and pressed in the appropriate hex hole for mounting, the holes are a little smaller than the nut in the design Please excuse the parts being 2 different colours i ran out of natural, but my plan was to allow the colour of the fan to glow through the case
Statistics
Likes
3
Downloads
0