(GL45) Autosampler HPLC to Glassware Adapter
Description
---------------------------------------------------------------------------------------------------------- ---------------------- UPDATE 19May2020 ------------------------------------------------------ I have added a second file for each outlet. The second file has a reduced inner diameter. This can be printed if you find your pieces are a bit too snug. We found that on some bottles, they were too tight, and became problematic when left too long on the reagent bottles. I have also removed the small stem for the HPLC tubing, as these were not needed. I also added a shorter cap piece to better fit with other manufactured pieces. ------------------------------------------------------------------------------------------------------------ This is a cap for use with typical laboratory glassware. The cap is designed to fit standard HPLC fittings and tubing. I have included not just the cap for the glassware (GL45 thread) but also the inserts if you want them. I have a 3-port, 4-port, and 5-port insert. These inserts can also be used with standard caps if you have them. Everything has been designed to fit with other typical laboratory glassware. You can print out of any material, but unless you are only using water, I would suggest chemically resistant materials such as polypropylene, nylon, PEEK, or other materials known to have high resistance to organic solvents, low concentration acids, and other chemicals commonly in use at your facility. Hope this helps you as much as it has helped me.
Statistics
Likes
4
Downloads
0