Zesty Nimble Motor Gimbal
Description
I made a swivel mount for the extruder stepper motor. At first, I was going to fasten to the tower with one long screw through the axis of the bearings, but I did not find a sufficiently long screw and I slightly altered the base. So you can probably do without the central screw and print the axis without a single hole. I also added a limiter so that the engine does not deviate too much back in some positions of the head. Two bearings 608 are used on the axis one after another through a gasket 0.5-1 mm thick.
Statistics
Likes
0
Downloads
0