40mm fan cover yin & yang
Description
I couldn't find a 40mm fan cover fitting my theme on my Ender 3 Pro. So I created a Yin and Yang design. When I screwed it on to the fan I noticed the noise went up a lot due to the restricted airflow I had with an uncovered fan. The solution was easy ... just a few distance holder to keep the cover close enough but still let enough air through. The distance tube is slim enough to fit into the pocket hole of the fan body. I'm using 4 screws of M3 by 30mm to screw everything together on my HeroMe fan duct.
Statistics
Likes
8
Downloads
0