Triumph TR6 Bumper Notch Cover
Description
For the Triumph TR6 Motorcar from years late 1973 to early 1974 where the owner has elected to remove the bumper overriders. On the rear bumper there are exposed/unsightly notch cutouts. This project is about a cover which screws into place to cover the notches. The front covers should be printed with 85% fill because its a press-fit, with a mallet. I have printed this in PLA but should be printed in ABS next No brim/raft For the rear cover, use scaffolding from baseplate to keep the counter-bores clean. Use #10-24 stainless fasteners.
Statistics
Likes
1
Downloads
0