SD Card relocate (improved T-slots)
Description
I printed the original of this vertically and although the original designer said that it would need "some sanding", by the time i got even close to fit there wasn't much "T" left in the T-slot. So, I cut the T's off the original design in Fusion and made new ones directly sketched over a 2040 rail profile from McMaster-Carr, then scaled back by 0.1 mm. The new design fits like a champ! mild pressure needed to slide into the rail (only trimming needed if you get elephants foot on your prints)
Statistics
Likes
2
Downloads
0