Futaba FXT Rear Arm/Hinge Mount
Description
Rear arm/hinge mount for the long since discontinued Futaba FXT. I had trouble finding this part (along with pretty much every other part except for the arms, dogbones, front carriers/spindles and rear hubs - all shared with the Tamiya Stadium Blitzer). Ream the arm hinge pin holes with a 3 mm drill bit. Use a M3 tap and M3 machine screws to attach this to the chassis. Update 11/05/21: Part/design updated to correct the hinge area mounting screws to the correct lateral spacing. This is labeled as "V2". When I originally designed/printed this part, I incorrectly measured the spacing based on a badly damaged chassis. I then further complicated the issue by using a M3D printer. When I updated the part with parameters/dimensions which work for most other 3D printers, I did not pick up on this dimension being wrong. The original part will "fit" but it is right on the edge (off by 0.5 mm). Not much, but enough likely to cause unnecessary frustration. Apologies on the mistake!
Statistics
Likes
6
Downloads
0