Partfan for CR-10S
Description
My original part fan broke, so I started my quest for a new one. I printed it as one piece, with the big flat surface laying on the print bed. Except for the screw posts I did not need any support material. You also could print the two parts seperately and glue them together. If you have longer screws you can (and should) extend the screw posts down to the printing bed in order to get it rid of those supports, giving you better results. I believe you need a silicone sock on your hotend in order for the PLA not to melt. Alternatively use a more heat resistant filament. The project comes as STL and SolidWorks
Statistics
Likes
4
Downloads
0