Longer LK1 Heated Bed Cable Support
Description
Cable Support for the heated bed plug on a Longer LK1 3D printer. It's purpose is to prevent fatigue of the heated bed wires, at the point where they meet the plug. The support has been designed to allow the LK1 printer to face forwards on a standard 600mm wide kitchen worktop, whilst ensuring the printer can reach the Y-axis limit switch, without fouling on the wall behind. To install the support onto the plug: 1. Disconnect the threaded connector from the control box 2. Pass the connector through the support entering from the support's top face 3. Slide the support along the cable up to the heater bed plug 4. Position rectangular portion over plug, 5. Clip in cable bundle to underside. 6. (Optional) Add a cable tie in the groove around the cylindrical portion for added security
Statistics
Likes
18
Downloads
0