Mask With Seal
Description
Ive tried the silicon route but to get it right, wasn't easy at all but i found Amos I clay that when it dries is a soft foam that worked amazingly well, I covered the front with duct tape and was not able to breath at all specially if you have a beard to (short one) it is difficult to get a good seal Spray painted it with 2 coats of undercoat 2 coats of black and two coats of sealant to make sure if any layers had wholes microscopic wholes that they would be sealed i have included a template to cut cut the shape of the filters out Ive also included quick hook clips for 10mm elastic thread through under back slot then down through middle then up through front and lastly down through back slot which will prevent it from slipping (print at 100% infill at .20 takes 18min for two sets) Original post his print works is designed for a Food-Safe 100% Silicone Seal. This is a one size fits all approach. The seal is just about as perfect as I can imagine. Comfort is also fantastic. Start to finish I explain the whole process here https://youtu.be/gwOZ_gwkojg Wearing this mask without doing a silicone pour would be extremely painful. The Silicone is required. Read this! I am in no way able to adequately scientifically test the device I design in this video and can make no claims as to its functionality. This mask is not approved by any regulatory body! If you print and wear one of these in any situation you will be doing so at your own risk!
Statistics
Likes
2
Downloads
0