Monoprice MP Delta Pro 5015 Part Cooling Upgrade
Description
The stock cooling fans on these machines frankly are no good for any decent overhangs or if you want to print faster. This double 5015 upgrade will more than satisfy the cooling needed here. I run them at around 50% and its plenty for me. This design I made uses the stock mounting holes and screws from the original shrouds except the 2 rear screws will now mount from the top rather than from underneath. Refer to photo for example. i would recommend printing the bottom half upside down and the top half upright but feel free to experiment if you wish. Hopefully this is helpful. I don't see a lot of parts for the mp delta pro out there. Thanks!
Statistics
Likes
13
Downloads
0