CR10 / Ender 3 Spool Holder
Description
This part is a one part low profile filament spool holder. I've swapped out my standard Ender 3 spool bracket with this. After viewing so many over engineered spool holders I came up with this one part design. Can be mounted horizontal or vertical. It will work with any 3D printer that has a frame than can take M3 or M4 bolts with, typically 20x40 6mm slot or 20x20mm 6mm slot. Designed for 8mm long bolts with T nuts. This can reduce the overall height of the printer so it can sit on a bookshelf, or anywhere where reduced headroom is important. Takes spools up to 85mm width, which is usually 1kg spools. Print with 20% infill minimum for strength, and min 1mm wall thickness ideally, though thinner walls will work just fine with lower mass spools.
Statistics
Likes
1
Downloads
0