GPW Shell Mod for G305
Description
This is my GPW shell mod for the G305. I do plan on refining the model and making different versions. THINGS YOU WILL NEED - The 3d print - A G305 - A rechargable AAA battery (rechargable via micro USB) - A 4 inch female to male micro USB cable - Hot glue or superglue INSTRUCTIONS: - Disassemble the G305 and save all screws - Make the prints - Take the bottom plate and glue the female end of the cable to the front, you will see a square to help line it up. I stripped the wire to help run it under the PCB. - Take the main PCB and line up the left and right switches then hold them in place with "switch_connect" stl with two screws on each - Remove the metal contact points from the battery holder and connect them to the battery however you feel to do so - Go ahead and plug in the switches and battery to the PCB, also make sure to plug in the male ind of the cable to the battery - Remove the DPI button from the G305 battery holder. Keep as much as you can - Glue the button onto the top shell using the two pegs on the inside - Take the DPI.stl print and glue it to the bottom of the DPI button - Once everything is in place, go ahead and assemble the mouse.
Statistics
Likes
23
Downloads
0