MakerBot Headphone Stand - Toluco Remix
Description
After reading the reviews of the Makerbot Headphone Stand a lot of people were saying that the flat top and sharp edges were causing dents on their headphone padding, some permanent. Obviously headphones are curved because our heads are curved. I decided to remix the original design and add a curved piece on the top. In the photos I've shown the additional piece compared to the original. When I brought the original design into Fusion360 it was very complicated with many faces, so I had to simplify the mesh which removed the Makerbot logo from the underneath. However this makes the design a little more simple and therefore prints slightly quicker. There are no supports or rafts needed to print this. The overhang parts print very well if your printer is set up correctly. I used my Sony Gold wireless headphones for the measurements. Those are the ones seen in the finished photos.
Statistics
Likes
31
Downloads
0