Joseph Joseph Kitchen Roll / Towel holder adapter
Description
Modern problems require modern solutions! I have a Joseph Joseph Kitchen roll (Kitchen Towel) holder which is fine for smaller rolls, but doesn't cater for larger rolls, such as Regina Blitz kitchen rolls. This redesigned end piece gives the extra height/length required to accept the taller rolls. Absolutely fine in PLA, it's plenty strong enough. Some minimal supports required for the two screw tabs, so ensure your support options allow for supports everywhere to allow for the minimal amount necessary (otherwise your slicer will try and print the tabs in mid-air!) I used a brim just to ensure the model stayed put, but if you trust your printer then it will probably be ok without one. There is a slight fillet/curve on the top (when it's orientated for use) to make it feel nicer in the hand, so you may like to give the model a gentle sanding/post processing to smooth it up. The second picture shows the existing piece, and then the following pictures show the updated 3D printed piece. If this helps anyone, please do post your makes and if you're feeling generous then feel free to send me a small tip.. every little helps! :)
Statistics
Likes
7
Downloads
0