Servo arm for MG90S metal geared servo, 40mm length - My Customized Servo Z probe arm
Description
I customized this to fit the metal geared servo I have, the MG90S, which is the metal-geared version of the regular 9 grams SG90 servo. The MG90S comes with black servo arm attachments that are a little bit longer than the white ones that come with the SG90. I customized it so the black servo arm fits perfectly in this printed item. It actually snaps right in so nice and tight that no glue or anything is needed to keep in this printed z-probe servo arm. It also fits exactly flush inside the printed servo arm. The arm length is 40mm. The arm length is 40mm but you can go back to the original and use the Thingiverse customizer like a did and change the arm length to your liking but then you would also need to change the other parameters to the ones I used to make it fit the MG90S which are listed below. I printed this on my Anet A8 Plus (w. E3D V6 hotend) using PETG but PLA is fine also. I sliced it with Cura 4.6.1 Customized version of https://www.thingiverse.com/thing:630632 Created with Customizer! https://www.thingiverse.com/apps/customizer/run?thing_id=630632
Statistics
Likes
4
Downloads
0