TYHI Mosquito Net - CR-10S Pro & Pro v2 Mosquito Hotend Carriage Mount
Description
Update 1/6/21 - Added a much-needed cable passthrough for the Mosquito fan. Now it can hold flush to the backplate. I went looking for a CR-10S Pro or Prov2 mount for the Slice Engineering Mosquito Hotend and found this option: https://www.thingiverse.com/thing:3716042, by Bcheirif. It seemed like a good quick solution, but didn't provide much lateral support for when you want to do any nozzle changes. So I used it as a base inspiration and valuable source of offset lengths, and got to work on this. Calling this the "TYHI Mosquito Net", mostly do to the open vent design at the top. With this setup, you do not need to adjust any firmware or stock settings. Nozzle placement is identical to that of the stock CR-10S hotend. I tried to make it so no additional hardware was required, but you will need the following: 5x M3 Screws - 2x Carriage Mount, 2x Fan Mount, 1x Fan Exhaust Mount 2x M3 Hex Nuts for the Fan Mounting Points Everything else should be plug and play. I love the design of the Mosquito Hotend, so this design is admittedly to show it off a bit. Otherwise, fan placement would be a little different. The "SOLO" model is a version of the Mosquito Mount, just for the Slice Hotend & Fan Assembly. THIS VERSION IS A GOOD STARTING POINT FOR YOUR OWN REMIX. I will likely update this with a few more revisions. Feel free to update me with questions/comments. I will try to make changes if requests are pertinent.
Statistics
Likes
20
Downloads
0