Life Size Kalista Spear (follow instructions carefully)
Description
To actually make this print work, you need to follow these instructions carefully Infill - 5% for the spear head, and 10-15% for the rest should work, maybe 30-50% on the two middle pieces or wherever the hands are intended to go, and on the bottom piece of the handle you could make it 100% infill because it is 7.5ft and will likely scrape the ground a lot (I did 5% for all and it was stable but clearly top sided and it could break) Wall length - 1mm layer height - 2mm but you could probably double that scaling *Most Important* - exactly 1316.3% a life size tips - number the parts, and keep track on which side is the top of the part and which is bottom - once this is printed, treat it with care because if it falls standing up it will absolutely break - ****USE A GLUE THAT WILL BIND THE PLASTIC TOGETHER SUCH AS 3D GLOOP, SUPERGLUE WILL END UP IN A FAILURE***** - Have fun! - Don't stab your foes irl with it
Statistics
Likes
2
Downloads
0