PC Engine/TG16 Jewel Case w/HuCard Holder v4.1 Final
Description
Remix from Jonn Blanchard (404). Got tired of waiting for the guy from pcenginefx forums to reply, then found out he's no longer printing these. Contact me if anything is wrong or needs adjustment. Print in .26 resolution with NO SUPPORT. Update 4.1 Final: Finally got all measurements right. This is the best version to use with standard CD case jewels. Separated the tab and made guides to glue it. DO NOT USE SUPPORT when printing! Update 3.4: Moved the jewel case top hole a few mm up from the previous version. Update 3.3: Changed the width of the holes that connect the top to 3.51mm after measuring an old CD case and move them lower matching said case (see pic). Haven't tested yet. Contact me if you do print it and any changes are needed. Update 3.2: Don't use support under the tab...terrible to remove. Raised the tab to 4.60mm. Update 3.1: Got the caliper...measured the tab and changed accordingly...also fixed the height of the tab to the original specs to hold the HuCard. I've also fixed the inner jewel used for a clear CD case...if needed I will post...otherwise this is just like the original case. Update 3.0: Added the tab because I didn't want the card to move around and its an iconic staple in gaming.
Statistics
Likes
7
Downloads
0