MHP Magpie - Ehdrien grip remix
Description
This is a custom grip for my MHP magpie build. I created this grip as the smallest LiPo I own didn't fit in Heath's original Magpie grip. The dimensions of my 850mAh LiPo are approximately 60x30x25mm. the front, back and side panels are pinned together for alignment and then glued together. you need 10 of the small pins. The large pin is for the battery access door. Don't glue the large pin, that one is meant to be removable for battery access. Please refer to the included image for print orientation. Print the pins laying down for best print layer strength. If you print the battery door standing upright you get smoother results but laying flat is also fine.
Statistics
Likes
89
Downloads
0