Anet ET4 upgrade: X gantry cable holder
Description
Simple upgrade to avoid the X gantry data cable to move at the board connector while Z axis is moving up and down, thus avoiding damage and possible breackage to the cable itself. The bottom bracket is attached to the back of the X stepper via 1mm thick sponge-like biadhesive tape. Screws don't need to be snug, just barely tightened. Needed: -nr 4 M3 screws (15-20mm thread lenght); -nr 4 M3 nuts. Note, bottom bracket versions: WITH SUPPORTS I placed 4 little cross at the bottom of the hex holes of the lower bracke to create the base for the supports. I found it was impossible for the supports to adhere to the bed without them. You can later remove the whole supports with a small cutter. WITHOUT SUPPORT Print as you like. Comments much appreciated.
Statistics
Likes
46
Downloads
0