PrintrBot ALU Filament Guide
Description
Wanted To Update This Description, So People Viewing Dont Think This Is Dead... Havnt Updated Or Mess With This, As My Original One Made Almost 3 Years Ago Is Still Performing Flawless! Gotta Say, Falling Off The Hobbed Gear Is Something I Really Dont Miss Happening. And With 3 Years Of Solid Performance I Think I Can Call This A Winner. Now My Design Skills Were Horrible Back Then, Square Shapes Was About All I Was Good At! I Think I Might Take Another Stab At This. I Just Started Planning A Redesign Of Some Of My Plastic Mods To My Simple Metal. Want To Redesign My Cable Chaine, My Fan Mounts, And Clean Up The Wiring. Its Becoming A Mess With All The Lights And Crap Added Over The Years. Keep Your Eyes Peeled For This! ************************************************************* Sometimes Simple Is The Best! Here Is One Of Those Times, V3 Is Working Great! And Its Really Small And Fast To Print. ************************************************************* Print At .2 100% Infill With Support; Rotated 90 On X ******************************************************** Unbolt The Lever With The Bearing In It By Removing The Hex Socket Head Screw From The Top Right Corner; Remove The Sleeve, And Replace With This Print. Tighten The Bolt Back Down Fairly Snug. The Printed Part Has A Slight Angle Built In To Pitch The Lever At An Ideal Angle. Helps The Filament Stay Nice And Straight And Helps Keep It On The Hobbed Gear!! *********************************************** Yay, Had Some Ideas, And Having Some Great Luck With It! Check Out V2 ************************************************* Spool Holder - Http://Www.Thingiverse.Com/Thing:581739 Fan Add On - Http://Www.Thingiverse.Com/Thing:581670 Fan Duct Pictured - Http://Www.Thingiverse.Com/Thing:367602 Wire Management - Http://Www.Thingiverse.Com/Thing:561148 Filament Guide - Http://Www.Thingiverse.Com/Thing:590750
Statistics
Likes
12
Downloads
0