Replacement Nintendo Wii balance board foot
Description
A direct replacement for the built-in feet on a Nintendo Wii balance board. This is necessary when the original ones get brittle and breaks after years of use. Simply print a replacement then move the parts from the faulty foot to make a full replacement On the bottom of the foot move across the rubber anti-slip disc. Fix in place with a small amount of superglue Inside the foot - move across the 15mm metal load spreading disc and the foam anti-rattle pad, this should still have some tack on it but if not, use a very small amount of adhesive to stick it in place. To get the old foot off the board, remove the 3 cross head screws in the surround that captures the foot. Be careful not to damage the wiring that connects to the strain gauge in each foot. Note When printing this design, flip it over in your print software so that the broad bottom of the foot is adjacent to the plate, this produces a better quality print.
Statistics
Likes
3
Downloads
0