3in MLR EVO Whoop AIO
Description
My edit of Dave_C FPV's 3in frame setup to accommodate a whoop board. I didnt stretch the frame but did move and delete some standoffs. Since theres more space between the standoffs I upped the top and bottom plates from 1.5mm to 2mm. At the moment I am getting files cut and will update this listing if there are any modifications that are needed to be done. Also included some parts to mount 20x20 board over a whoop board as well as the TPU parts in the pictures. At the moment the chin guard interferes with the tarsier and there could be a little more room between the back of the tarsier and the whoop board. To run the hybrid in this configuration I had to go to the 10cm ribbon cable for the tarsier which I hope is correct and connected properly.
Statistics
Likes
12
Downloads
0