Triple-40 Fan Shroud (E3D V6)
Description
This is my remix of the E3D V6 Fan Shroud by carlol. The simplicity and small size of his design is perfect for a direct drive setup but it was clear from the comments that many would like to see a version that was made for (3) 40mm fans. Truth be told, there was already one remix that achieved this but for me personally, I am very picky with aesthetics and that particular remix "didn't quite do it for me" so I set out to create this little modification. The changes made to the E3D V6 Fan Shroud by carlol were the addition of mounts 40mm fans and the opening up of the airflow path from the front hot-end fan to the hot-end so that the bottom section of the hot-end was not blocked. The mounts were inspired by the many 30mm to 40mm adapters and I considered using them with the E3D V6 Fan Shroud by carlol, but I preferred a 1-piece design... something I didn't need to assemble. Ultimately, the print settings you choose is up to you but if you use the settings I've listed here, you will find that the Triple-40 Shroud ends up being a lightweight, strong shroud. The final weight for me was 24g. Just mount your fans using M3 screws and you're all set. Happy printing!
Statistics
Likes
31
Downloads
0