100mm tube (drain, PVC) closing grill
Description
I'm working on some rain water drainage in my garden and the end of the tube is simply above the ground, and open. To prevent to get anything inside the tube and clog the tube, I would need some grill type closing. (let the water out, but don't let anything inside. So I have designed a simple grill to close the end of the drainpipe. It took appr. 1.5 hours to design it in Fusion 360. The grill fit to any 100 mm outer diameter pipe (PVC, or drain pipe) As there can be smalll size deviances, I did not make it tight fit, but there are 4 small wings/arms with hole, so you can use small screws to hold the grill in place. I have included two versions, one is 3 mm thick, the other is only 2 mm. I have printed the 2 mm version, and it took 2.5 hours. The printing time for the 3mm has been predicted by Cure to 3.5 hours. No need support, but I used brimm (it may do not need as well)
Statistics
Likes
12
Downloads
0