FlyFive33 Tiny Trainer Rear Fin
Description
Revised rear fin for the Tiny Trainer. Its taller so it still allows you to flip over using turtle mode, but not so tall that it loses the character of the original design. No more giant Flip Stck rod that came with the TT. The bottom of the fin is also tapered to match the taper of the top of the poly carbonate canopy that comes with the Tiny Trainer. You can also drill a 2mm hole in the Tiny Trainer poly carbonate pod and run a 2mm x 5mm or 6mm screw up from the underside of the canopy and into the fin. The 2mm screw will pressure fit into the TPU. This will hold the front of the fin down. You can easily mark where the hole needs to be drilled by installing the fin on the canopy at the rear standoffs then push a small nail through the small hole in the front of the fin.
Statistics
Likes
12
Downloads
0